|
TO ALL EMPLOYERS AND APPRENTICES
(Not Just Master Roof Tilers Apprentices)
PLEASE NOTE
NSW ROOF TILING APPRENTICESHIP COURSE
ENROLMENTS ARE NOW OPEN FOR A NEW STAGES 1 and 2
COMMENCEMENT FEBRUARY 2010
A joint venture of
The Roofing Industry Association of NSW Inc. and COMET TRAINING
Held at 6 - 8 Railway St LIDCOMBE
CERTIFICATE III in ROOF TILING
CPC 30808
The Roofing Industry Association of NSW Inc. (formelly Master Roof Tilers and Slaters Association of New South Wales Inc), in conjunction with Comet Training Pty. Ltd (NTIS Code 1398) will commence another apprenticeship course in Roof Tiling which will be available for registered apprentices. When completed, apprentices will have attained the qualification of Certificate III (CPC 30808) in Roof Tiling.
The training will be conducted at Comet Training premises, 6-8 Railway Street Lidcombe, close to Lidcombe railway station ad other transport. The training of apprentices will be conducted by trainers from the Roofing Industry Association of New South Wales Inc and Comet Training Pty. Ltd. The Roofing Industry Association's Master Tradesmen in Roof Tiling and Slating trainers have many years of experience in this method of off site training and until recently were engaged by TAFE NSW to deliver the Certificate III Roof Tiling Course at the Nirimba campus. Each trainer is still connected to the roofing industry on a day to day basis and therefore fully conversant with all the current roofing industry requirements, codes and legislation.
To gain the Certificate III in Roof Tiling the apprentices are required to successfully complete the training and study required off site, over a period of three years. The off site training period that is required for each year is only one day per week, for the period of eight hours, for fourteen weeks.
Should you require further information on the above please do not hesitate in contacting the Association
on 02 9674 7474 or Comet Training Pty Ltd on 9649 5000.
Safety Roof Rail Installation Program
Industry Induction Course
Introduction
- Welcome
- Assessment of job site to determine practical use of safety rails
- Selection of suitable equipment
- Maintenance of equipment
- Personal protective equipment
- Identification of site safety rails
- Safe use of steps, ladders and trestles
- Safe use of harness
- Safe erection and testing of safety rails
- Safe dismantling of safety rails
- Demonstrate the procedures of repairing roof to AS.2050
- Demonstrate the procedures for handling, stacking and storing safety rail equipment
- Occupational Health, Safety & Environment
Duration
- This module involves 8 hours off-the-job training
Purpose
- To develop safety practices in handling, erection and dismantling of Safety-Rail apparatus used above and below eaves gutter line of the roof structures
Prerequisites/Co requisites
- The learner has completed a safety site induction course (Green/White Card)
- An applicant may seek recognition for this entire module through the RPL process details in the RPL Policy Manual of the training provider
Contact Rick Heron for more information on 02 9674 7474 or email enquiries@roofingassociation.com.au
OR Ian Cochrane at Comet Training Pty Ltd on 9649 5000
|
